Following Up On The Palm Pre InvisibleShield

Palm Pre Invisible Shield Follow up

Here are some follow up pictures of my three day old InvisibleShield install on my Palm Pre (see the original install here).

Most of the air bubbles worked their way out, but there's still one on the right edge that refuses to go away.  It gets smaller day by day, so maybe it'll just take some more time before it vanishes completely. 

The edges were OK at best; there's some overhang on the front bottom edges.  However, the battery cover installation was pretty much flawless and looks great.

Had I taken a little bit more time, I may have been able to get a perfect install.  The good thing is, you can just send your InvisibleShield back and get a brand new one, which I'll probably do once I get my replacement Pre.

Before:

After:

UPDATE:

4 days after installation, the bubble is gone!

Before:

After:

The skin certainly looks much better than it did immediately after the installation.  Just remember to work slow and get out as many air bubbles as you can before the skin starts to dry. 

The edges are staying stuck on really well, even on the bottom edge where I screwed up.